Baking Soda Blasting does not produce heat like abrasive blasting; therefore it cannot heat up and distort sheet metal. It will not harm Glass, Chrome or Rubber products. It effectively removes paint, body filler, undercoating, seam sealer and etc. without damaging the substrate. Sodablasting leaves a coating on the metal that will inhibit flash rusting. This coating will need to be pressure washed off before applying any coating. Please contact your local distributor for further information on this process.
2. FIRE / SMOKE REMEDIATION
Baking Soda Blasting is the preferred choice in removing smoke damage on wood, concrete, tiles, metal and etc. as it not only cleans these substrates back to either new or pre-fire condition, but absorbs the odor during the process.
3. MOLD REMEDIATION
Baking Soda Blasting actually kills mold spores and removes mold growth from virtually any substrate. As in smoke removal, the soda absorbs the odor during the process.
Baking Soda Blasting will remove anti-fouling bottom paint from boats without damaging the gel coat. It will also strip the out drives without damaging the aluminum and will not harm any water pump components should it get into the passage ways. Baking Soda is water soluble.
5. METAL STRIPPING
Strip aluminum, brass, steel, anodized coated metals, pot metal, cast iron, titanium, chrome plating, stainless steel, magnesium and etc. all without damage, distortion or changing the surface. Soda Blasting does not generate heat and will not warp metals. Disclaimer: Air pressure alone can sometimes distort thinner aluminum sheet metal, contact your local distributor for training and techniques.
6. CONCRETE CLEANING
Removes graffiti, paint, grease, striping, dirt and grime without damage to the surface.
7. SWIMMING POOLS
Cleans tiles and concrete, removing dirt, grease, mold, grime, calcium deposits and etc. without damage.
8. FOOD SERVICE APPLICATIONS
Removes baked on grease, dried food and etc. leaving a 99.9% bacteria free surface without any damage to the finish of chrome plated and stainless steel fixtures and utensils.
9. CARBON FIBER PRODUCTS
Soda Blasting removes paints and coatings without damage to the carbon fiber surfaces. See you local distributor for training and techniques.
10. FIBERGLASS PRODUCTS
Soda Blasting will remove paint and coatings from fiberglass products. Will not harm gel coated surfaces and with proper instruction coatings can be removed from non gel coated fiberglass without damage. See you local distributor for training and proper removal techniques.
11. ASPHALT AND TAR REMOVAL
Soda Blasting is used in asphalt plants for cleaning equipment, silos, tack trucks, tanker trucks and etc. without damaging the substrates. Also will remove tack overspray from concrete curbing without damage.
12. INDUSTRIAL APPLICATIONS
Soda Blasting will safely clean electric motors, pumps, conveyor belts, and numerous types of equipment of grease and coatings without damaging surfaces or harming bearing operation. Hydraulic shafts and seal areas can also be cleaned without damage.
13. BRICK AND TILE CLEANING
Soda Blasting will remove paint and coatings from brick and tile (including ceramic tile) surfaces usually without damage. Some brick needs to be tested to make sure that blasting is a good coating removal solution. Contact your local distributor for training and information.
14. GRAFFITTI REMOVAL
Baking Soda Blasting will remove graffiti from most substrates normally without any damage. Contact your local distributor for details on particular substrates.
15. Soda Blasting is gentle enough to strip just about any type of substrate without surface damage. If you have a project or substrate not listed please contact your local distributor. The Soda Works distributor network consists of contractors operating full time blasting facilities. This way you can be sure that the information you receive is up to date and based on personal experience, not word of mouth.